For more information, please visit RAITTO.
### **Step-by-Step Guide to Installing PVC Skirting Boards Effortlessly**.
Redoing the skirting in your home with PVC boards is a practical and aesthetically appealing solution. This guide will take you through the entire process of installing PVC skirting boards in a few straightforward steps. Using numbered lists will help break down the tasks, making it easy to follow and implement.
#### **1. Gather Materials and Tools**.
Before you begin, ensure you have all necessary materials and tools ready.
1. **Materials:**.
- PVC skirting boards.
- Adhesive (specifically for PVC).
- Caulking (for sealing gaps).
- Paint (if required).
.
2. **Tools:**.
- Tape measure.
- Mitre saw (or a handsaw).
- Spirit level.
- Corner mitre box.
- Pencil.
- Sandpaper.
- Adhesive gun.
- Utility knife.
.
#### **2. Measure the Wall Length and Skirting Boards**.
Accurate measurements are essential for a professional finish.
1. Use the tape measure to determine the length of each wall where you will install the skirting boards.
2. Note down each measurement.
3. Measure the PVC skirting boards and mark the cutting points using a pencil.
#### **3. Cut the Skirting Boards**.
Precision is key when cutting your skirting boards.
1. Use the mitre saw or handsaw to cut the boards to the required lengths.
2. For inside corners, set the mitre saw to a 45-degree angle and cut accordingly for a neat fit.
3. For outside corners, cut the board ends at complementary 45-degree angles so they fit together seamlessly.
4. Smooth any rough edges with sandpaper.
#### **4. Prepare the Wall Surface**.
Ensure the wall surface is clean and even.
1. Remove any old skirting boards, adhesive, and nails.
2. Clean the wall to remove dust, grease, or any other debris.
3. Use the spirit level to check for evenness. If the surface is uneven, consider applying a filler to level it out and then sand it smoothly.
#### **5. Apply Adhesive to the Skirting Boards**.
Prepare to attach the skirting boards to the wall.
1. Load the adhesive gun with the PVC adhesive.
2. Apply a smooth, continuous bead of adhesive along the back of each skirting board.
3. Focus on applying extra adhesive to corners and areas where the boards will overlap.
#### **6. Attach the Skirting Boards to the Wall**.
Now, it's time to fix the boards in place.
1. Position the skirting board along the wall according to your measurements.
2. Press firmly and evenly along the length of the board to ensure it adheres well.
3. Use the spirit level to check that the board is straight and make adjustments as needed.
4. Hold or use temporary supports if necessary until the adhesive sets.
#### **7. Fill Gaps and Joints**.
Seal any gaps for a seamless look.
1. Use caulking to fill any gaps between the skirting board and wall, as well as any corners and joints.
2. Smooth the caulking with a damp finger or putty knife for a clean finish.
3. Allow the caulking to dry thoroughly, as per the manufacturer's instructions.
#### **8. Finishing Touches**.
Finalize the installation with some finishing touches.
1. Sand down any rough areas where caulking was applied.
2. If planning to paint the skirting board, lightly sand the entire board to ensure the paint adheres properly.
3. Apply a primer coat if needed, followed by your chosen paint. Let each coat dry thoroughly between applications.
#### **Conclusion**.
By following these steps, installing PVC skirting boards can be an efficient and rewarding DIY project that enhances the look of your home. With careful preparation and precise execution, you'll achieve professional-looking results that are both durable and attractive.
Click here to get more.
If you want to learn more, please visit our website how to install pvc skirting boards.